IMPORTANT ! The LRMB only works with Wi-Fi in the 2.4GHz band. If the network is only 5GHz, make sure to also activate the 2.4GHz band

1. Install and connect the LRMB gateway inside the home in an area covered by Wi-Fi. (In order to optimize communication with the POOL COMMAND  module, choose the most visible installation locations on the pool.)

2. Note the name and password of the Wi-Fi network to which the LRMB module will be connected. This information will be requested when commissioning the module.

3. With the phone in hand, stay next to the LRMB module then click on “Yes” when the application suggests installing the LRMB module”

4. Follow the commissioning instructions
5. At the end of commissioning, wait approximately 1 minute to check that the red LED turns solid green, signifying that the module is correctly connected to the Internet. In the event of an update, the LED may flash green for approximately 1 minute. If the LED of the LRMB does not turn green (probable error entering the Wifi password), complete the installation of the POOL COMMAND module, then go to the "Settings" tab, click on "My relay" then " Network Settings" and re-enter the Wi-Fi credentials.